Ok so Scott here again, this time I decided to go ahead and take things to a simple level based off a write up done by Syed Muhammad Shaheryar. I have seen so many comments and issues with people flashing firmware to their factory TronXY X5S control board, now this should work for flashing the firmware on the X3S as well but the firmware I included will need some edit work unlike for the X5S. This Version of Arduino IDE will work just like any other but it can be installed on a thumb drive or SD card and moved from one computer to the next without having to install anything on that computer. it should also work on other boards but I have not tested it.
What's New In The 3D Printer World
By doing it this way You can copy the same file onto a thumb drive and run off ant windows computer. and use to flash other boards... Read MoreSaturday, 24 February 2018 01:52
If you do not fallow it step by step this might happen. If you had arduino installed before you must remove it first as this versi... Read MoreTuesday, 06 March 2018 19:23
While I have seen this work on Windows 10 I have also seen it be an issue if you have another Windows 7 computer I would try that.... Read MoreTuesday, 06 March 2018 19:32