What's New In The 3D Printer World

Mk7 / Mk8 HOTEND ASSEMBELY REBUILD

      Ok so Scott here again lately I have been seeing a lot of post and comments about the factory Tronxy hotend so I figured I would go ahead and write up a quick tech article. While this is not the only way to rebuild or assemble the hotend assembly this is the way I do it. This also works on the E3D hotends I have but the throat is different on them. So let’s start with a few tools.

Continue reading
  11348 Hits
  4 Comments
Recent Comments
Scott Worthington
this part of the site does not have a upload options. the forum does.
Thursday, 15 February 2018 22:53
Scott Worthington
Normally I start out tightening it before it's cold then heat it up and check make sure it did not change.
Wednesday, 23 January 2019 20:01
11348 Hits
4 Comments

To keep the site live and make improvements Please consider Donating. Thank you for your donation.