Once again Scott Here to see if I can’t help you understand the something else I have seen questions about in the 3D printing community. This Time around I’ll go over the G-code used By Chitu on their F mini control board and other custom made control boards used by Tronxy and several other companies now. This control board comes on the Tronxy X5SA, X5ST, X5S-E2, XY-3 and XY-2 to name a few.
PLEASE NOTE CHANGING THESE SETTING WILL change your printers behavior. Therefore I do not recommend changing settings yourself without understanding what each setting your adjusting does.
What's New In The 3D Printer World
158266 Hits
99 Comments
Recent Comments
What you need to do to turn on heated bed is open notepad then type
m8027 t1
M8500
Then save file to SD card. Then go to file ri... Read More
Friday, 27 April 2018 14:16
So unlike marlin you can upload seperate commands instead of the whole file?
Friday, 27 April 2018 20:22
Yes your uploading g code to change setting not complete firmware
Friday, 27 April 2018 20:23
158266 Hits
OK Scott Here again like normal. This time I had a little help from Norman Gilman with some pictures and a few of the steps, helping to get my mind in gear to write this. Now please note Neither Norman Or I installed these setup with the auto bed leveling because we use glass beds to thick for the factory blue sensor to see the bed through the glass.
42798 Hits
Recent Comments
great guide! how do you like the E3d mount you have in the picture? I am debating which one to do before I do my upgrade
Wednesday, 06 June 2018 14:41
So I completed the Upgrade last night I turned on the power had the touch screen was working well. turned it off and now i turn it... Read More
Sunday, 10 June 2018 17:14
ive only just installed this kit having putting it off for 6 months excellent no problems and its far better than the original dri... Read More
Wednesday, 13 March 2019 02:12
42798 Hits